The K3D60a 3-axis sensor is suitable for force measurement in three mutually perpendicular axes. This 3D force sensor is available in the measuring ranges 10 N to 500 N.
Up to a nominal load of 100 N, these sensors are made of aluminum; from a nominal load of 200 N, they are made of stainless steel.
The K3D60a 3-axis force sensor is equipped with full-bridge strain gauges. The signals from the full-bridge strain gauges each correspond to a force component in the x-, y-, and z-directions.
The vector decomposition is therefore achieved mechanically, by three orthogonally arranged spring-joint guides (double bending beams), and additionally by the arrangement of the strain gauges in the Wheatstone bridge, so that residual transverse forces and moments are also compensated electrically/circuit-wise. The three double cantilevers in this 3D force sensor are connected in series.
Calibration of 3-Axis Force Sensors – From Standard (cv) to High Precision (s)
A key characteristic of 3D force sensors is crosstalk: applying a force also triggers a measurement in the two unloaded axes. Thanks to several compensation mechanisms (mechanical and electrical), crosstalk is typically less than 3% of the nominal load. Crosstalk is reproducible and proportional to the amplitude of the applied force. By applying an additional compensation matrix, crosstalk in all axes can be reduced to a maximum of less than 1%.
By default, you receive two factory calibrations, each with two measurement points:
one without a compensation matrix (“cv”) and one with extended matrix compensation (“s”).
For detailed proof of the sensor's linearity, you can optionally extend the calibration to 4 or 6 measurement points:
This ensures your sensor is optimally calibrated to your application from the very first measurement.
Optional special version
- Protection class IP68: from rated force 200 N
- Vacuum version from 10⁻⁵ mbar
- Pressure range up to 8 bar
