Force sensor KMz
The force sensors KMz are equipped with threaded bolts for the force insertion. They are therefore suitable both for measuring the compressive force, as well as to measure the tensile force.
To avoid the introduction of bending moments it is recommended to use at least one knuckle.
For the measuring principle of the force sensors KMz the deformable body is a membrane (for example, at KM10z, KM26z), or a cylindrical compression body is used for example at KM16z, KM30z, KM50z, KM70z.
KM10z
Membrane load cell, 25 N ... 200 N, accuracy class 1%;
Ø 9,8mm x 19,8mm, 3m teflon-cable
KM16z
Rod end force sensor, 2kN ... 50kN, accuracy class 1%;
Ø 18mm x 40mm / Ø29 mm x 50 mm, 3m cable
KM26z
Membrane load cell, 20N ... 5kN, accuracy class 1%;
Ø 25,4mm x 49mm, 3m cable
KM30z
Rod end force sensor, 1 kN ... 50 kN, accuracy class 0,5%; 30mm x 90mm, 3m cable
KM50z
Rod end force sensor, 100 kN, accuracy class 0,5/1%; ⌀ 50mm x 130mm, 5m cable
KM70z 200KN
Rod end force sensor, 200kN, accuracy class 0,5/1%;
Ø 70mm x 260mm;
Mmale thread M45x3;
connector M12;
10m Connector M12/f/10m;