I have some questions regarding the mechanical interfaces for these 6-axis sensors:
- Do you recommend using only pins, or both a central washer and pins?
- In case you recommend one, which tolerances and thickness do you recommend the central washer?
- Any recommendation about pin tolerance?
- Any recommendations about hardness for pin/washer?
And another question: I understand it doesn't matter whether the stator or the rotor is connected to the moving body the position of the sensor, as long as the connection cable doesn't suffer too much stress. Also, it doesn't matter the actual position of the sensor (tilted, horizontal, vertical...) as it's properly fixed. Could you confirm all this?
PS: I'm posting here after getting no answer by email. In the FAQ section only the last question is partially covered.