PCAN-USB adapter for connection to CAN Bus and to PC

Stress Analysis Strain Gauge; dimensions: 16 mm x 12.2 mm, GL: 6mm, TC: steel

static mixer for use with UHU-Plus-Endfest-300

Stainless, antimagnetic;
Glare-free, black epoxy coating;
form: 10, 3c, ca. 120 mm.

Printed Circuit Board 14mm x 14mm with bridge-completion for quarter bridge. 3 pieces 350 Ohm, 0,01%, TK1;

gelatinous, 2-component adhesive in 50 ml double cartridge;
50ml Methacrylate, 50ml Hardener;
Operating temperature -55 ° C ... 120 ° C

Rod end force sensor, 100 kN, accuracy class 0,5/1%; ⌀ 50mm x 130mm, 5m cable

as a free service we offer the configuration for GSV-6K and GSV-6L,
setting parameters are selectable

Connector for the analog output of the measuring amplifier GSV-1A4

Sensor cable, 24-pin, 4x6x0.06mm², outer diameter 6.6 mm, PUR

Ultraminiature belt sensor, 100 N, accuracy class 1%; 31mm x 24mm x 4mm;
1m connection cable

Measuring amplifier as an PCB for sensors with straingages. Serial Port RS232, RS422, CANOpen, analogue output -5V...+5V, limiting frequency 250Hz, input sensitivity from 2mV/V.

Printed Circuit Board 35mm x 35mm x 1, 5mm with 100µm Cu, inkl. bridge completion for 3 pieces of quarter bridges;
9 pieces 350 ohms, 0.1%, TC 5 ppm / K;

Dispensing gunl for 37ml and 50ml double cartridges.

Stainless, antimagnetic;
Glare-free, black epoxy coating;
form: 20, AA, 120 mm.

Strain sensor 120mm x 20mm x 11mm, 5m cable

Cotton swab lint-free

Diaphragm load cell, 5 kN, accuracy class 1%;
Ø 12mm x 7.5 mm, 3 m cable

Sensor cable, 12-pin, 12 x 0.0127mm², outer diameter 1.72 mm, PFA

Detection of the characteristic value and traceability on DAkkS torque device; 0.025Nm... 50Nm

Adapter for connecting IEPE sensors to GSV-8DS;

Printed Circuit Board 35mm x 35mm x 1, 5mm with 100µm Cu, inkl. bridge completion for 3 pieces of quarter bridges;
9 pieces 120 ohms, 0.1%, TC 5 ppm / K;

resistance: 350 Ohm, 0.1%, TK5, 0805 SMD

Sensor cable, 12-pin, 12 x 0.061 mm², O.d. 3.1 mm, PUR